Shop fox W1686 - User Manual

INSTRUCTION MANUAL
MODEL W1686
SPINDLE SANDER
Phone: 1-360-734-3482 • On-Line Technical Support: tech-support@woodstockint.com
COPYRIGHT © AUGUST, 2002 BY WOODSTOCK INTERNATIONAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT
THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.
Printed in Taiwan
ONLINE MANUAL DISCLAIMER
THE INFORMATION IN THIS MANUAL REPRESENTS THE CONFIGURATION OF THE MACHINE AS IT IS CURRENTLY BEING SHIPPED. THE MACHINE CONFIGURA-
TION CAN CHANGE AS PRODUCT IMPROVEMENTS ARE INCORPORATED. IF YOU OWN AN EARLIER VERSION OF THE MACHINE, THIS MANUAL MAY NOT
EXACTLY DEPICT YOUR MACHINE . CONTACT CUSTOMER SERVICE IF YOU HAVE ANY QUESTIONS ABOUT DIFFERENCES. PREVIOUS VERSIONS ARE NOT
AVAILABLE ONLINE.

Summary

Machine Specifications

SAFETY

Safety Alert Symbols

Standard Safety Instructions

General safety guidelines for operating the machine, points 1-11.

Additional Safety Precautions

Eye Protection & Extension Cord Guidelines

Additional Safety Instructions For Sanders

Specific Sander Safety Practices

Lists safety practices specific to sanders, including workpiece handling and dust.

Avoiding Potential Injuries

Safe Workpiece Handling Techniques

Illustrates and describes safe methods for handling workpieces during sanding.

ELECTRICAL REQUIREMENTS

110 V Operation

Details electrical requirements and circuit considerations for 110V operation.

Grounding (110 V)

Explains the importance and procedure for grounding the machine.

220 V Operation

Details electrical requirements for 220V operation, including plug/receptacle.

Grounding (220 V)

Emphasizes grounding requirements for 220V operation.

ASSEMBLY INSTRUCTIONS

Unpacking and Initial Inspection

Component Layout

Table;Trunnion Attachment

Sanding Spindle Mounting

Sanding Spindle Removal

Sanding Sleeve Replacement

Table Insert Installation

ADJUSTMENTS

Positive Stop Bolt Adjustment

OPERATIONS

Test Run Procedure

Steps for performing an initial test run to check for issues.

Standard Sanding Procedures

Techniques for effective and safe sanding of workpieces.

MAINTENANCE

General Maintenance Checks

Sanding Sleeve Care

Wiring Diagram

Shop fox W1686 Specifications

General

Type	Oscillating Spindle Sander
Spindle Speed	1725 RPM
Dust Port	2-1/2"
Motor	1 HP
Spindle Sizes Included	1-1/2", 2"
Voltage	110V