ADM-860C 04/14/0819
now be displayed as nnS ERASED. There will be no value associated with that place in the sequence and the
reading may be left blank or may be replaced with a new reading. The sum function will disregard the erased
reading unless it is replaced. The average function will display the revised number of readings included in the
average and the revised average.
5.3.5 CLEAR MEMORY
The memory is cleared and the store mode is exited by pressing the SHIFT key followed by the CLEAR key.
This sequence removes all readings from memory. Press the STORE key a second time and a new STORE
sequence will be initiated. NOTE: Readings are still in memory after the SHIFT key has been pressed.
Pressing the SHIFT key a second time will return the meter to the previous mode, display all existing parameters
and the existing readings will remain in memory.
5.4 DATA DOWNLOAD TO A PRINTER
Readings may be downloaded directly from the meter to a printer, either as individual readings or multiple
readings from memory. Shortridge Instruments, Inc. supplies the Seiko™ model DPU-H245, a palm-sized,
portable printer which uses rechargeable batteries. Other compatible printers may also be used.
The Seiko model DPU-H245 printer is shipped complete with an RS232 printer (serial) cable, null modem
adapter, battery and power cable.
Connect the barrel connector on the serial cable to the RS232 jack on the right side of the meter. The red dot
on the connector aligns with the red rectangle on the lower part of the jack. Connect the null modem adapter
to the DB9 connector on the serial cable and then plug the null modem adapter into the serial port on the printer.
Refer to the instructions supplied by the printer manufacturer for any further setup requirements. The RS232
port on the meter is set for 9600 BAUD, 8 data bits, no parity, and one stop bit. There is no flow control.
5.4.1 DOWNLOAD INDIVIDUAL READINGS TO A PRINTER
Turn the meter and the printer on. The default mode and units will be printed if the printer is turned on before
the meter. Select the desired mode and units and press the READ key. The printer will print the information
displayed throughout the reading sequence, including the mode, density selections, and readings. Press the
READ key to print another reading. Example printouts are shown below.
If DIFF PRES and ENGLISH are selected and the READ key is pressed, the following will be printed:
DIFF PRES
In: 0.0468
If a velocity or flow mode is selected and the TemProbe is being used, when the READ key is pressed, the
printout will be formatted like the following:
VELGRID
LOCAL DENS
FP: 1576
If a velocity or flow mode is selected and the TemProbe is not being used, when the READ key is pressed, the
printout will be formatted like the following:
VELGRID
LOCAL DENS
STD 70
/ F
FP: 1576
5.4.2 DOWNLOAD READINGS IN MEMORY TO A PRINTER
Readings stored in memory may be downloaded from the meter to a printer after the sequence of readings has
been completed. Connect the printer to the meter using the RS232 cable as described in Section 5.4 DATA
DOWNLOAD TO A PRINTER. Turn the printer and meter on.
To Next Page
Loading...
Need help?
General
