ADM-860C 04/14/0841
now be slid over the ends of the spring rods.
The location and correct combinations of frames, support dowels, dowel extenders and frame support cups to
be used with each size are shown in Figures 10.4 through 10.8. The 8.5" dowel extenders are used with the
23.5" fiberglass support dowels when necessary to adjust for variations in frame size.
The 2'x2', 2'x4' and 1'x4' tops do not require dowel extenders. When using the 2'x2' frame, insert the support
dowel end pins into each corner bracket of the 2'x2' frame assembly as shown in Figure 10.4. The dowel end
pins are inserted into the outer set of frame support cups when assembling a 1'x4' top and into the inner set
when assembling a 2'x4' top as shown in Figures 10.5 and 10.6. The 1'x5' top requires an 8.5" dowel extender
at the bottom of each support dowel. The dowel end pins are to be inserted into the inner set of frame support
cups as shown in Figure 10.7.
The 3'x3' top requires dowel extenders added to both the top and bottom of the support dowels. The dowel end
pins are to be inserted into the frame corner brackets as shown in Figure 10.8. Each frame piece has been
labeled to indicate positioning of the support dowels for different frame sizes.
When the top assembly is complete, the springs on the short rods of the top support assembly should be
compressed to approximately 50% of normal extension.
10.5 HANDLE
Attach the handle assembly to the handle plate using the knob type screw provided with the handle.
SEE THE NEXT FOUR PAGES FOR DIAGRAMS OF THE CORRECT METHOD FOR
ASSEMBLING STANDARD FLOWHOOD TOPS AND FRAME SETS.
To Next Page
Loading...
Need help?
General
