ADM-860C 04/14/088
FP: ± nnnnnn
Indicates that the displayed result represents a velocity measurement (fpm).
/ F: ± nnn.n
Indicates that the displayed result represents a temperature measurement (
/ F).
Hg: nn.n
Indicates that the result represents an absolute pressure measurement (in Hg).
IN: ± n.nnnn
Indicates that the result represents a differential pressure measurement (in wc).
Metric Units
Bar: n.nnn
Indicates that the result represents an absolute pressure measurement (bar). (One bar = 100 kPa).
/ C: ± nnn.n
Indicates that the displayed result represents a temperature measurement (
/ C).
LS:c ± nnnn
Indicates that the result represents an air flow measurement (L/s). "C" indicates that the result has been
compensated for backpressure effects.
LS:u ± nnnn
Indicates that the result represents an air flow measurement (L/s). "U" indicates that the result has not been
compensated for backpressure effects.
Pa: ± nnn.nn
Indicates that the result represents a differential pressure measurement (Pa).
MS: ± nnn.nn
Indicates that the displayed result represents a velocity measurement (m/s).
4.3 FUNCTION READOUTS
The following prompts and messages are listed in alphabetical order.
$ $ $ $ $ $ $ $
Blocks of pixels will be displayed to test the operation of the display each time the meter is turned on.
nnc nnnn
Displays the number of nonbackpressure compensated readings in memory and the average of just the
nonbackpressure compensated readings taken during a FlowHood reading sequence. Displays the average
of just the backpressure compensated readings taken during a FlowHood reading sequence.
nnc NONE
Displayed if there are no backpressure compensated readings in memory during a FlowHood reading
sequence.
nn
R n.nnnn
Displays the current reading and its place in the reading sequence during a STORE sequence. Number of
decimal places will vary.
nn
R NP 0
Indicates that the current reading in a manual STORE sequence is a negative pitot tube reading.
To Next Page
Loading...
Need help?
General
