ADM-860C 04/14/08ii
8.0 TEMPERATURE MEASUREMENT 36
8.1 TEMPROBE 36
8.2 AIRDATA MULTITEMP 36
9.0 AIR FLOW MEASUREMENT 39
9.1 FLOWHOOD FUNCTION 39
9.2 BACKPRESSURE COMPENSATION 39
10.0 FLOWHOOD ASSEMBLY 40
10.1 UNPACKING 40
10.2 FRAME ASSEMBLIES 40
10.3 FABRIC TOPS 40
10.4 TOP SUPPORT ASSEMBLY 40
10.5 HANDLE 41
11.0 FLOWHOOD OPERATING PROCEDURE 46
11.1 AIR FLOW - NONBACKPRESSURE COMPENSATED READINGS 46
11.2 AIR FLOW - BACKPRESSURE COMPENSATED READINGS 46
11.2.1 MEMORY DISPLAY IN FLOWHOOD MODE 47
11.2.2 RATIO ERR DISPLAY 47
12.0 SPECIAL BALANCING PROCEDURES 48
12.1 PROPORTIONAL BALANCING 48
12.2 LARGE RETURN AIR GRILLES 48
12.3 KITCHEN EXHAUST HOODS 48
12.3.1 RANGE EXHAUST FILTERS AND GREASE EXTRACTORS 48
12.4 CONSTANT VOLUME CONTROLLERS 48
12.5 LINEAR SLOT DIFFUSERS 49
12.6 SIDEWALL REGISTERS 49
12.7 14"x14"x14" SHORT TOP SET 49
12.8 SYSTEM PROBLEMS 49
13.0 CORRECTION FACTORS 50
13.1 BAROMETRIC PRESSURE DENSITY CORRECTION - LOCAL DENSITY 50
13.2 BAROMETRIC PRESSURE DENSITY CORRECTION - STANDARD DENSITY 50
13.2.1 STANDARD DENSITY - TEMPROBE USED 50
13.2.2 STANDARD DENSITY - TEMPROBE NOT USED 50
13.3 TEMPERATURE DENSITY CORRECTION 50
13.4 RELATIVE HUMIDITY CORRECTION 50
13.5 HOT WIRE ANEMOMETER VERSUS AIRDATA MULTIMETER 51
14.0 METER ACCURACY FIELD TESTING 52
14.1 METER ZERO FUNCTION 52
14.2 DIFFERENTIAL PRESSURE FUNCTION 52
14.3 ABSOLUTE PRESSURE FUNCTION 52
14.4 AIR FLOW ACCURACY 52
14.5 DUCT TRAVERSE COMPARISONS, INCLINED MANOMETER, MICROMANOMETER 53
14.6 DUCT TRAVERSE USING THE AIRDATA MULTIMETER 53
14.7 BACKPRESSURE COMPENSATED COMPARISON READING 53
14.8 NONBACKPRESSURE COMPENSATED COMPARISON READING 53
15.0 METER MAINTENANCE 54
16.0 FLOWHOOD MAINTENANCE 54
17.0 RECALIBRATION AND REPAIR INFORMATION 55
AIR BALANCE MANUALS & TRAINING PROGRAMS 55
WARRANTY 56
APPENDIX A - NIST VELOCITY TESTING 57
To Next Page
Loading...
Need help?
General
