ADM-870C 07/14/0914
READING
This message is displayed during differential pressure measurements, and also during the first reading period of
some automatic reading sequences. It is also displayed during the manual reading which is taken when a sequence
of TREND readings is halted.
RECHARGE
This message signals that the batteries have reached the end of their useful charge, and must be recharged. The
meter will turn off following the display of RECHARGE.
REPL nn?
This message is displayed when the operator has pressed the MODE key once while recalling stored readings. This
message indicates the current reading displayed using RECALL (nn
S) will be replaced with a new reading when the
operator presses the READ key.
REPLACING
This message is displayed when the current reading displayed using RECALL (nn
S) is being replaced with a new
reading.
SHIFT
This message is displayed when the upper half of the keys are activated by pressing the SHIFT key.
SHUT DOWN
The meter will display SHUT DOWN and turn itself off if the battery charge becomes too low or if the meter is
exposed to temperatures beyond the specified limits.
STD 70
/ F or STD 21.1/ C
This message will be flashed during air flow or velocity measurements performed without the TemProbe. The
resulting flow or velocity value will be calculated using the standard temperature, 70
/ F or 21.1/ C. The correction
for the ambient barometric pressure will still occur.
STORE
This message may be one of the parameters displayed following SHIFT/SHIFT and indicates that the meter is being
used in the STORE mode.
STORE FULL
This message indicates that the number of readings in memory has reached the maximum storage capacity of 200
readings.
STORE MODE
This message is displayed when a key other than READ, STORE or RCL is pressed when readings are in memory
and HALT has been selected. This message may be displayed when the SHIFT key is pressed to indicate that the
meter is in the STORE mode. The mode may not be changed until the readings in memory are cleared by pressing
SHIFT/CLEAR.
STORE RDY
This message indicates that the meter has been placed in the memory mode, and that readings will be sequentially
stored in memory when the READ key is pressed.
STD DENS
This message indicates that readings will be calculated to display standard density sea level equivalent (mass flow).
It will also be displayed during the actual measurement interval.
TEMP
This signal will be flashed when the Temperature mode is selected, and also upon each subsequent operation of the
READ key.
TEMPROBE
This message is displayed to indicate a change in the TemProbe connection status during a STORE sequence.
TOO HOT or TOO COLD
If the internal temperature of the meter exceeds its operational limits, it will display TOO HOT or TOO COLD and shut
down. However, if there are readings in memory, the meter will continue to display TOO HOT or TOO COLD, and
To Next Page
Loading...
Need help?
General
