ADM-870C 07/14/0939
shown in Figures 10.5 and 10.6. The 1'x5' top requires an 8.5" dowel extender at the bottom of each support dowel. The
dowel end pins are to be inserted into the inner set of frame support cups as shown in Figure 10.7.
The 3'x3' top requires dowel extenders added to both the top and bottom of the support dowels. The dowel end pins are
to be inserted into the frame corner brackets as shown in Figure 10.8. Each frame piece has been labeled to indicate
positioning of the support dowels for different frame sizes.
When the top assembly is complete, the springs on the short rods of the top support assembly should be compressed to
approximately 50% of normal extension.
10.5 HANDLE
Attach the handle assembly to the handle plate using the knob type screw provided with the handle.
SEE THE NEXT FOUR PAGES FOR DIAGRAMS OF THE CORRECT METHOD FOR
ASSEMBLING STANDARD FLOWHOOD TOPS AND FRAME SETS.
To Next Page
Loading...
Need help?
General
