15
4. Master (Auto)/Slave Mode
01) While in the main menu, press the UP and DOWN buttons until the display shows .
02) Press the ENTER button to enter the menu.
03) Press the UP and DOWN buttons to choose one of the two modes:
04) When the display shows , press the ENTER button to activate Master/Auto mode.
The display will show .
05) Press the MENU button to enter the Master/Auto Mode.
06) The device is now operating in the Master/Auto Mode and will display its built-in auto show.
07) When the display shows , press the ENTER button to activate the Slave Mode.
08) The device is now operating in the Slave Mode and will react the same as its master device.
5. Sound-controlled Mode
01) While in the main menu, press the UP and DOWN buttons until the display shows .
02) Press the ENTER button to enter the menu.
03) Press the UP and DOWN buttons to activate/deactivate the Sound-controlled Mode.
Choose between .
04) Press the ENTER button to confirm your choice.
6. LED Display Continuous/OFF
01) While in the main menu, press the UP and DOWN buttons until the display shows .
02) Press the ENTER button to enter the menu.
03) Press the UP and DOWN buttons to choose between the two options:
LED Display OFF after 110 seconds
04) Press the ENTER button to confirm your choice.
7. LED Display Reverse Mode
01) While in the main menu, press the UP and DOWN buttons until the display shows .
02) Press the ENTER button to enter the menu.
03) Press the UP and DOWN buttons to choose between the two options:
04) Press the ENTER button to confirm your choice.
8. Reset
01) While in the main menu, press the UP and DOWN buttons until the display shows .
02) Press the ENTER button to enter the menu.
03) Press the UP and DOWN buttons to activate/cancel reset. Choose between .
04) If the display shows , press the ENTER button. The device will reset the settings.
05) If the display shows , press the ENTER button. The device will return to the main menu.
To Next Page
Loading...
Need help?
General
