SHOWTEC Showmaster 24 - Front Panel Control Descriptions; Channel and Flash Controls; Mode, Function, and Master Controls

5
Controller Front
1) Preset A LEDs: Show the current intensity of the relevant channel numbered from 1-12.
2) Channel sliders 1-12: These 12 sliders are used to control and /or program the intensities of
channels 1-12.
3) Flash-buttons 1-12: These 12 buttons are used to bring an individual channel, to full intensity.
4) Preset B LEDs: Show the current intensity of the relevant channel numbered from 13-24.
5) Scene LEDs: Light when relevant scenes are active.
6) Channel sliders 13-24: These 12 sliders are used to control and /or program the intensities of
channels 13-24.
7) Flash-buttons 13-24: These 12 buttons are used to bring an individual channel, to full intensity. They also
are used for programming.
8) Dark-button: This button is used to momentarily black out overall output.
9) Down/Beat Rev: DOWN functions to modify a scene in Edit mode; BEAT REV is used to reverse the
chasing direction of a program with regular beat.
10) Mode Select / Rec Speed: Each tap will activate the operating mode in the order: CHASE / SCENES,
Double Preset and Single Preset. Rec Speed: Set the speed of any of the programs chasing in
Mix mode.
11) UP/CHASE REV: Up is used to modify a scene in Edit mode. CHASE REV is to reverse the chasing
direction of a scene under Speed Slider control.
12) Page-button: Tap to select pages of scenes from Page 1-4.
13) Delete/RevOne: Delete any step of a scene or reverse the chasing direction of any program.
14) Segment Display: Shows the current activity or programming state.
15) Insert / % or 0-255: Insert is to add one step or steps into a scene. % or 0-255 is used to change display
value cycle between % and 0-255.
16) Edit / All Rev: Edit is used to activate Edit mode. All Rev is to reverse the chasing direction of all
programs.
17) Add or Kill / Rec Exit: In Add mode, multiple scenes or Flash buttons will be on at a time.
In Kill mode, pressing any Flash button will kill any other scenes or programs.
Rec Exit is used to exit from Program or Edit mode.
18) Record/Shift: Record is used to activate Record mode or program a step. Shift functions only used with
other buttons.
19) Master A-button: Brings channel 1-12 to full of current setting.
20) Park-button: Used to select Single/Mix Chase, bring Channel 13-24 to full of current setting, or
momentarily program a scene into Master B slider, depending on the current mode.
21) Hold-button: This button is used to maintain current scene.
22) Step-button: This button is used to go to next step when the Speed Slider is pushed to the bottom or in
Edit mode.
23) Audio-button: Activates audio sync of chase and audio intensity effects.
24) Master Slider A: This slider controls overall output of all channels.
25) Master Slider B: This slider controls the chase of all programs.
26) Blind-button: This function takes the channel out of the chase of a program in CHASE / SCENE mode.
27) Home-button: This button is used to deactivate the Blind.
28) Tap-Sync-button: Repeatedly tapping this button establish the chase speed.
29) FULL ON-button: This function bring overall output to full intensity.
30) BLACK OUT-button: This button is used to kill all output with exception for that resulting from Flash and
FULL ON.
31) Fade Time Slider: Used to adjust the Fade Time.
32) Speed Slider: Used to adjust the Chase Speed.
33) Audio Level Slider: This slider controls the sensitivity of the Audio input.
34) Fog Machine button