Showven Sparkular - Interface Display and Error Information; Error Information Codes

3. RFID area:
RFID card comes together with HC8200, it is a safety design, allow machines to identify the
parameter and types of consumable it adding to the hopper of machine. It is obligatory to
swiping the card before adding the consumable HC8200 to the hopper of machine.
Note: Please note that the card enables the unit for 10-20 minutes of operation (which is the
amount of time each bag of HC8200 last). The RFID card is disposable and it is disabled after it
has been swiped.
▲Interface
1. Main Interface:
DMX Address 1
580
Displays DMX Address
Display inner core temperature of machine
Display error information when error occurs
2. Error information:
Error information
Explanation
E0 System IC
Systematic error
E1 Motor Protect
Over current protection of the motor
E2 Temp. Sensor
Temperature sensor is not connected or
damaged
E3 P Temp. Over
The equipment stops due to the over
temperature of the chassis
E4 Time Remain
Activated time for the machine is not
enough, please swip RFID card
E5 K Temp. Over
The equipment stops due to over
temperature of the inner core
E6 Heat Fail
Heating fail, problem on heating PCB of
mainboard
E7 Tip Over
Tilt sensor activated when machine slant
more than 45 degree