Shure BLX2 - Page 5

Shure Incorporated
5/28
3. 1.
2.
4.
Install batteries and turn on transmitter.
On the transmitter, set the group and channel to match the receiver. The audio LED on the receiver should illu
minate.
If setting up additional systems, leave the first transmitter and receiver on. For each additional receiver, manual
ly set the group to match the first receiver. Note: The receiver will automatically perform a channel scan to find
an available frequency after the group has been selected. Set the transmitter frequency to match the receiver.
If sound is too faint or distorted, adjust the gain accordingly.