What to do if Shure Microphone system transmitter indicator LED flashing red?
If the transmitter indicator LED is flashing red, try the following: * Replace the transmitter batteries. * Change the receiver and transmitter to a different group or channel. * Identify and remove any nearby sources of RF interference. * Replace transmitter batteries.
What to do if my Shure BLX24R/SM58-H10 receiver LED screen is off?
If the receiver LED screen is off: * Make sure the DC adapter is securely plugged into the electrical outlet. * Make sure the receiver is powered on.
General| Type | Handheld |
|---|---|
| Microphone Type | Dynamic |
| Microphone Capsule | SM58 |
| Polar Pattern | Cardioid |
| Frequency Range | 50 to 15, 000 Hz |
| RF Bandwidth | 24 MHz |
| Number of Channels | 12 |
| Modulation | FM |
| RF Output Power | 10 mW |
| Signal-to-Noise Ratio | > 100 dB |
| Total Harmonic Distortion | < 0.5% |
| Receiver Display | LED |
| Handheld Mic Power | 2 x AA batteries |
| Battery Life | Up to 14 hours |
| System Type | Wireless |
| RF Frequency Band | H10 |
| Frequency Step Size | 25 kHz |
| Dynamic Range | 100 dB |
| Operating Range | 100 m (300 ft) |
| Audio Frequency Response | 50 Hz to 15 kHz |
| Receiver Type | Diversity |
| Receiver Outputs | 1/4" (6.3 mm) and XLR |
| Power Source | 2 x AA batteries |
| Power Supply | 12-18 VDC |
| Output Connector | XLR and 1/4" |
Overview of the receiver front panel controls and indicators.
Covers LED, power switch, and mic input jack.
Covers antenna, buttons, display, battery, and gain.
Covers LED, buttons, and display.
Details meanings for Green, Red, Flashing Red, etc.
How to manually set the transmitter group.
How to manually set the transmitter channel.
Covers first and additional receiver setup steps.
Steps for setting receiver group and channel manually.
Procedure to lock or unlock the transmitter controls.
Procedure to lock or unlock the receiver controls.
Guidance on optimal microphone positioning for clear sound.
Instructions for proper positioning of headworn microphones.
How to adjust gain on the BLX1 transmitter.
How to adjust gain settings on the BLX2 transmitter.
Details expected battery life and LED indicators.
Solutions for interference and signal loss.
Details working range, frequency response, and THD.
Specifies the audio input levels for the BLX1.
Physical size and weight of the BLX1 transmitter.
Covers audio input, dimensions, weight, power, battery.
Covers output impedance, audio level, RF sensitivity.
Covers output impedance, audio level, RF sensitivity.
Covers water usage, cleaning, ventilation, heat sources.
Addresses plug types, grounding, and power cord protection.
Covers EU, US, and Canadian regulatory approvals.
Covers licensing, FCC rules, and user guidance.
Covers licensing, RSS, and ICES-003 compliance.
Covers ACMA class license and frequency band restrictions.
To Next Page
