English
11
TRANSMITTER SETUP
LX1 Body-Pack Transmitter Battery Installation (Figure 9)
1. With the transmitter POWER PWR/OFF switch in the OFF position, press down on the
OPEN side of the battery compartment cover, slide it back and flip it open.
2. Insert a new 9V alkaline battery in the compartment (DURACELL
MN1604 recom-
mended). Observe proper battery polarity (“+/–”).
IMPORTANT: A fresh 9V alkaline battery should provide 18 to 20 hours of
operation. However, an 8.4V nickel-cadmium (nicad)battery will only pro-
vide 3 hours of operation. Carbon-zinc and zinc-chloride batteries will not
provide sufficient power, and are not recommended.
LX2 Hand-Held Microphone-Transmitter Battery Installation (Figure 10)
1. With the transmitter PWR/OFF switch in the OFF position, hold the upper part of the
transmitter and unscrew the battery cover.
2. Install a fresh 9V alkaline battery (DURACELL MN1604 recommended). Make sure
the battery terminals match the terminals in the transmitter.
3. Screw the battery cover back into place.
To Next Page
Loading...
