Shure Microflex MXWNCS8 Manual

Shure Incorporated
94/100
Analog Connections
Outputs
Configuration Impedance
Clipping Level (minimum)
Line Aux Mic
Active Balanced 310Ω +26.2dBV +16.2dBV −3.8dBV
Input(s)
Configuration Impedance
Clipping Level (minimum)
Line Aux
Active Balanced 10.6kΩ +23.8dBV +10.8dBV
Headphone Output
6.35mm(1/4")TRS,100mW,350Ω,dualmono(willdrivestereophones)
0 dBV = 1 V RMS; 0 dBu = 0.775 V RMS; 0 dBV = 2.2 dBu
Digital Signal Processing
AD/DA Converter
24bit,48kHz
Latency
Estimated Nominal, ±0.1 ms
Analog-to-Dante 0.21ms
Dante-to-Analog 0.24ms+TN
T = Network latency in milliseconds, as set in Dante Controller.
Note: Dante network latency is typically associated with the receiving device.
Networking
Network Interface
Four-Port Gigabit Ethernet Switch, Dante digital audio
Uplink Port (Port 4)
Selectable, blocks multicast traffic
Power over Ethernet (PoE)
Provided on Port 1 to power MXWAPT
Cable Requirements
Cat 5e or higher, shielded, 100 m maximum between network devices
Network Addressing Capability
DHCP, link-local, static
N

Shure Microflex MXWNCS8 Specifications

General

Brand	Shure
Model	Microflex MXWNCS8
Category	Microphone system
Language	English