Shure PSM900 - Adding Transmitters to the Cuemode List; Auditioning Mixes; Exiting Cuemode; Managing Cuemode Mixes

Shure Incorporated
20/31
1.
2.
3.
4.
1.
2.
•
CueMode lists are retained even if CueMode is exited, the bodypack is turned off, or batteries are removed.
Note: Set the channel frequency and assign display names for each transmitter before creating your CueMode list.
Adding Transmitters to the CueMode List
Note: The transmitter must be from the same frequency band as the bodypack.
Open the battery door and press the enter button.
From the main menu, scroll to UTILITIES and press enter. Select CueMode and press enter again.
Align IR windows and press sync on the rack unit.
The LCD displays SYNC SUCCESS after frequency and name data are uploaded to the CueMode list. It also displays
the CueMode number for that transmitter and the total number of transmitters.
Repeat the above step for each transmitter.
Note: Syncing while in CueMode does not change any of the settings on the bodypack.
Auditioning Mixes
Enter CueMode from the UTILITIES menu.
Usethe▼▲buttonstoscrollthroughyourCueModelisttohearthemixes.
Exiting CueMode
Exit CueMode by pressing enter and selecting EXIT CUEMODE.
Managing CueMode Mixes
While in Cue Mode, you can access the following menu by pressing enter:
REPLACE MIX
Selectandpresssynconarackunittouploadnewdataforthecurrentmix(forexample,ifyouhavechangedthetrans
mitter frequency).
DELETE MIX
Removes the selected mix.
DELETE ALL
Removes all mixes.
EXIT CUEMODE
Exits CueMode and returns the bodypack to the previous frequency setting.
Frequency Scan
Use a frequency scan to analyze the RF environment for interference and identify available frequencies.
Channel Scan Press the scan button on the bodypack. Finds the first available channel.