Shure UR5 - Syncing Transmitters to MTx List; Transmitter Sync Procedure; Specifications

11
SPECIFICATIONS
RF Carrier Range
470–952MHz(variesbyregion)
Modulation
FM,±45kHzmaximumdeviation
Antenna
RredictiveSwitchingDiversity
Dynamic Range
>100dBm=,A-weighted
RF Sensitivity
<-106dBm12dBSINAD,-88dBm30
dBSINAD
Spurious Rejection (ref.
12dB SINAD)
>80dB(typical)
Squelch Threshold
30dB SINAD(±3dB)normalsetting
Compatible Channels
Perband:40(banddependent)
Tuning Bandwidth
60–72MHz(banddependent)
Frequency Stability
±2.5ppm
Pilot Tone
UHF-RMode:32kHztonekeypilot
AxientMode:28kHztonekeypilot
Audio Frequency
Response
50Hz-16kHz
Ultimate Quieting
>100dBm=,A-weighted
Total Harmonic Distortion
(ref. ±20 kHz deviation @1
kHz)
<0.4%THD(typical)
Signal-To-Noise Ratio
(A-Weighted)
90dB(typical)
Companding
PatentedShureAudioReference
Companding
Camera Output
Electronicallybalanced
Configuration:mono
TA3Maximumoutputpower:adjustable
-35dBVto+10dBVpeak
PinAssignment:
Pin1=Gnd
Pin2=Hot
Pin3=Cold
Headphone Output
AdjustableRange
Configuration:Unbalancedmono
(L=R),1/8thinch
Minimumloadimpedance:9.5ohms
Impedance:3.5ohm
Maximumoutputpower:100mW
PinAssignment:
Tip=Hot
Ring=Hot
Sleeve-Gnd
Operating Temperature
-18°Cto+57°C(0°to+135°F)
Battery Life
4hoursAAAlkaline,8hoursShure
RechargeableLi-ion
Net Weight
200g(withAAbatteries)
Dimensions
83mmX65mmX22mm
Syncing Transmitters to the MTx List
AftercreatinganMTxlist,youcansynctransmitterstothelistentries.Whenyou
syncatransmittertoalistentry,ittransferstheRFsettingandnameofthatentryto
thetransmitter.
Note:
• Transmittersmustbefromthesamefrequencybandastheportablereceiver.
• SyncingwhileinMTxmodedoesnotchangeanyofthesettingsontheportable
receiver.
1. EnterMTxmode(UTILITIES>MTxMODE>ENTER MODE).
2. Usethe▼▲buttonstoselectanentryfromthelist.
3. Pressentertoaccessthesubmenuforthatentry.
4. HighlighttheSYNCmenuitem.
5. AlignthereceiverandtransmitterIRwindowsandpressentertobeginthesync.
ThescreendisplaysSYNC SUCCESSwhencompleted.
6. Repeatforeachtransmitterinthelist.