EasyManuals Logo

Shure V-15 Type III User Manual

Shure V-15 Type III
22 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
OPERATION
The recommended stylus forces for optimum results are listed under
"Specifications." Forces greater than the indicated
"Maximum"should
not be used.
The
V-15
Type
Ill
Cartridge should be installed only in arms especially
designed for low tracking forces and having low friction at all bearing
surfaces, such as the Shure SME arm. Although the V-15 Type
Ill
car-
tridge will track records at
%
gram, it may be necessary, when used in
certain phono arms, to increase the tracking force for optimum results.
The
V-15
Type
I11
Cartridges play monophonic
LP
as well as stereo
records.
The
V-15
Type
Ill
Stylus incorporates a new retractile design that pre-
vents audible record-scratch or stylus damage when excessive force is
applied to the stylus.
NOTE: For playing 78 rpm records the Model
VN78E [13 x 63 microns
(.COO5
x
.0025
in.)
I
Biradial (Elliptical) Diamond Stylus is available. The
78 rpm
biradial stylus is an industry "first." It was developed to
sig-
nificantly reduce pinch effect and tracing distortion.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Shure V-15 Type III and is the answer not in the manual?

Shure V-15 Type III Specifications

General IconGeneral
TypePhono Cartridge
CategoryAccessories
Frequency Response20 Hz - 20 kHz
Stylus TypeElliptical
MountStandard 1/2 inch
Channel Separation25 dB at 1 kHz
Load Impedance47 kΩ
Compliance25 x 10-6 cm/dyne
Channel Balance2 dB
Output Voltage3.5 mV
Recommended Load Capacitance400 to 500 pF

Related product manuals