- 95 -
Select the pulse of the output from the transducer. Levels are among Low, Medium and High, which
depends upon the depth. Low is proper to research precise a fish school but it is not suitable to
measure a deep depth. High is opposite from Low.
(☞ The default setting is Medium.)
2.4. Output Power
Select the output from the installed transducer. Levels are from off to 3. It should be careful about the
depth. If you set high level in a sallow depth, the Fish finder screen turns to red. You see nothing
expect red on the screen.
(☞ The default setting is 3.)
2.5. Alarm
2.5.1. Depth
2.5.1.1. Deep Depth Alarm
It alarms when the set deep depth is out of the range.
(☞ The default setting is OFF.)
2.5.1.2. Deep Depth Range
Setup the range of deep depth alarm
(☞ The default setting is 0M.)
2.5.1.3. Shallow alarm
It alarms when the set shallow depth is out of the range.
(☞ The default setting is OFF.)
2.5.1.4. Shallow range
Setup the range of shallow depth alarm
(☞ The default setting is 0M.)
2.5.2. TEMP(Temperature)
2.5.2.1. High alarm
It alarms when the set high temperature is out of the range.
(☞ The default setting is OFF.)
2.5.2.2. High Range
It alarms when the set high temperature is out of the range.
(☞ The default setting is 0.)
2.5.2.3. Low alarm
It alarms when the set low temperature is out of the range.
To Next Page
Loading...
