SIAM SUDOS-mini 2 - Supplement 5. Transferring Data to a Computer

48
Charging is recommended at positive temperatures (+ 5 to + 30 C).
Do not charge the battery at temperatures below 0 °C!
Supplement 5. Transferring data to a computer
Attention! To avoid errors when transferring data to a
computer, carefully read and strictly follow the requirements of the
"SIAM Database v2.5" User's Manual.
1) Perform the data transfer to a computer in the following
sequence:
2) Connect the tool with the interface cable to the computer, the
message will appear on the display:
В Ы П О Л Н Я Е Т С Я
О Б М Е Н Ч Е Р Е З
U S B
This mode can be exited and re-entered by pressing the MODE
button.
3) If this is your first connection to a computer, install the USB
driver. In the "New Hardware Wizard" window check "Yes, only this time"
as shown in Figure 2, click "Next".
Check "Install from Specified Location" (see Figure 3), click "Next"
button.
Check the 'Include next search location' box (see figure 4), specify
the path to the driver information. Specify the folder where the drivers
atmel_devices_cdc.cat and atmel_devices_cdc.inf are located, click the
"Next" button.
In the window shown in Figure 6 click "Continue Anyway".