SIAM SUDOS-mini 2 - Page 57

57
In order to save the valuable data — transfer it to the computer
database before initialization of memory.
The initialization process does not change the current time and date
and they can be left without correction or changed partly.
Attention! Initialing cannot be conducted, if the battery cell is
discharged (the indicator is flashing). Besides, the device cannot be
switched off during the process of initialing before its completion.
In order to clean memory — press "MODE" consequently until the
window of the memory capacity and cleaning appears on the indicator.
Press "INPUT/OUTPUT" button (word "NO) starts flashing). In order to
clean memory — set "YES" as it is shown in exam
Then press "MODE" button. There will appear the following
window on the dicplay:
С И М В . О Т Ч Е Т 3 0 0 8
Э Х О Г Р А М М 3 1 0
О Ч И С Т К А П А М Я Т И Д А
In order to cancel the cleaning process — press "MODE" button.
О Ч И С Т И Т Ь П А М Я Т Ь ?
В Ы У В Е Р Е Н Ы ?
In order to clean storage— press "INPUT/OUTPUT" button. The
storage cleaning process will start. After the storage is cleaned — there
appears the window to correct time and date.
1 2 : 2 0 : 2 6
2 4 / 0 9 / 0 8