Figure 6: Assign device name
7.1.1.4 Allocating device names
Select the desired device name. Assign the device name to the marked and found
device using the command “Assign name”. The device name must be identical to the
names previously configured under “Properties”. The identification is done via the MAC
address or via the flash test. To get the MAC address, please have a look at the side
label of SIG200.
Figure 7: Device names
7
SIG200 CONFIGURATION
16
O P E R A T I N G I N S T R U C T I O N | Sensor Integration Gateway - SIG200 8017853/2019-06-06 | SICK
Subject to change without notice
To Next Page
Loading...
