As a next step, the different subslots (2-5; corresponding to IO-Link ports 1-4) (where
IO-Link or Standard I/O devices are connected) must be configured. Select correspond‐
ing to the process data length of the IO-Link device a matching IO-Link submodule in
the catalog on the right side and move it to the corresponding subslot (2-5) via Drag &
Drop.
Subslot 2.2. is linked to SIG200 Port S1.
Subslot 2.3 is linked to SIG200 Port S2.
Subslot 2.4 is linked to SIG200 Port S3.
Subslot 2.5 is linked to SIG200 Port S4.
Refer to the documentation for the IO-Link device for the required process data lengths
of the IO-Link device.
NOTE
In case you would like to use your IO-Link device in SIO mode, just use a digital input or
digital output module on the corresponding subslot.
NOTE
There is no configuration for Pin 2. Pin 2 is always 0 in case there is no physical connec‐
tion. In case there is a physical connection, the signal will be automatically transferred
without any further configuration and can be accessed through SIG200 IO-Link Master
subslot 2.1.
NOTE
In order to get valid process data for the logic editor submodule 1.1, the Profinet input
and output process data in the logic editor must be connected (see "Device Model ",
page 13).
Figure 8: Device overview
7.1.1.5 Addressing modules
The I/O addresses can be selected and changed by selecting the IO-Link modules.
SIG200 CONFIGURATION 7
8017853/2019-06-06 | SICK O P E R A T I N G I N S T R U C T I O N | Sensor Integration Gateway - SIG200
17
Subject to change without notice
To Next Page
Loading...
