During the selection of the IO-Link module, the IO-Link parameters of the respective
port can be changed using the “Module parameters” menu item. E.g: validation and
backup.
Figure 9: Module parameters
7.1.1.6 Ending configuration
Click on “Compile” and download the configuration.
Figure 10: Compile
7.1.2 Operation via PROFINET
The SIG200 can exchange process data and parameters via PROFINET. To do so, the IO-
Link Master has to be connected to a suitable programmable logic controller (PLC).
7 SIG200 CONFIGURATION
18
O P E R A T I N G I N S T R U C T I O N | Sensor Integration Gateway - SIG200 8017853/2019-06-06 | SICK
Subject to change without notice
To Next Page
Loading...
