FIND ME function Clicking on this button the "SF" LED next to the power port of the SIG200 will
flash with 1Hz until the button is clicked again. The function is intended to
allow you to identify the device when already mounted to an application.
NOTE
While FIND ME is active, no other interface navigation is possible until
pressing the STOP button on the dialogue box.
RESTORE FAC‐
TORY SETTINGS
Clicking on this button the SIG200 will reset all settings to the factory
defaults. As a factory default, all ports are configured as digital inputs.
The selection of the RESTOR FACTORY SETTINGS has to be double checked
in a "Confirm Action" box.
Any setting currently stored in the device is overwritten if "OK" is clicked.
After clicking "OK", a "Success" box will appear indicating that the connected
SIG200 has been restored to factory default settings.
NOTE
While both of the dialogues boxes are active, no other interface navigation is
possible.
NOTE
The Restore Factory Settings button works from any of the configuration
pages.
NOTE
The IP Address of the device will be set to the default value after performed
"Restore Factory Settings". In case of "Restore Factory Settings" via Profinet
the IP Address will be set to 0.0.0.0 according to the specification.
SIG200 CONFIGURATION 7
8017853/2019-06-06 | SICK O P E R A T I N G I N S T R U C T I O N | Sensor Integration Gateway - SIG200
43
Subject to change without notice
To Next Page
Loading...
