•
Connect your logic blocks with drag & drop with the inputs and outputs. First click
on the triangle on the input, hold the line and connect it to a triangle of the logic
block.
•
Please note to use always the upper inputs first, starting at A, then B, then C. In
case you use only two inputs please use always the top two inputs A+B and not e.
g. B+D.
•
Please note whether the values are Integer or Boolean it is only possible to con‐
nect Integer with Integer and Boolean with Boolean. Boolean values have a black
triangle. Integer values are easily identifiable by a red triangle.
Figure 28: Possible connections
By clicking on logic block you get information about the possible connections to this
individual block.
Figure 29: Several inputs and outputs
It is possible to connect several inputs and outputs with logic blocks.
•
A combination of logic blocks is possible as well.
•
Pay attention to inputs and outputs (Integer/Boolean).
8
DEVICE FUNCTIONS
80
O P E R A T I N G I N S T R U C T I O N | Sensor Integration Gateway - SIG200 8017853/2019-06-06 | SICK
Subject to change without notice
To Next Page
Loading...
