SICK SIG200 - Page 86

Description Division between the two input values.
Number of inputs 2
Input data type Integer
Input description num1: first input value
num2: second input value
Number of outputs 2
Output data type Output 1 ("/"): Identical to input data type
Output 2 ("/0"): 1-bit
Output description result: Result after dividing the two input val‐
ues
divByZero: When dividing by 0 (not possible)
this output is set
Settings No settings available
Description Modulo operation between the two input val‐
ues.
Number of inputs 2
Input data type Integer
Input description num1: first input value
num2: second input value
Number of outputs 2
Output data type Output 1 ("/"): Identical to input data type
Output 2 ("/0"): 1-bit
Output description result: Result with rest after dividing the two
input values
divByZero: When dividing by 0 (not possible)
this output is set
Settings No settings available
Description Multiplication between the two input values.
Number of inputs 2
Input data type Integer
Input description num1: first input value
num2: second input value
Number of outputs 1
Output data type Output 1 ("x"): Identical to input data type
Output description result: Result after multiplying the two input
values
Settings No settings available
Description Negation of the input value either one´s or
two´s complement depending on the configu‐
ration.
Number of inputs 1
Input data type Signed Integer
Input description input: analog input value
Number of outputs 1
Output data type Output 1 ("-"): Identical to input data type
Output description result: The one's or two's complement of the
input value. (So the analog output value is the
opposite of the input value).
Settings Selection of the one's or two's complement
(Default Two's Complement)
8 DEVICE FUNCTIONS
86
O P E R A T I N G I N S T R U C T I O N | Sensor Integration Gateway - SIG200 8017853/2019-06-06 | SICK
Subject to change without notice