SICK SIG200 - Page 89

Description Conversion of four digital inputs to an analog
half byte value.
Number of inputs 4
Input data type Input 1 ... 16: 1-bit
Input description in1: first digital input
in2: second digital input
in4: third digital input
in8: fourth digital input
Number of outputs 1
Output data type Output 1: Integer or UInteger, 8 or 16 bits
Output description analogValue: analog half byte output value
Settings To select which half byte should be connected
to the output (Default First half byte)
If First half byte selected send lowest 4 bits
(bits marked with x)
----|----|----|xxxx
If Second half byte selected send bits marked
with x
----|----|xxxx|----
If third half byte selected send bits marked
with x
----|xxxx|----|----
If Fourth half byte selected send bits marked
with x
xxxx|----|----|----
Description The input signal is delayed by the configured
time.
Number of inputs 1
Input data type 1-bit
Input description input: input value
Number of outputs 1
Output data type 1-bit
Output description output: when the input becomes true, the out‐
put becomes true after a preset time delay.
The output remains true as long as the input is
true. When the input is false or becomes false,
the output becomes false with no delay.
Settings OnDelay: Set delay for a rising edge transmit‐
ted to the output (Default 1 ms)
OffDelay: Set delay for a falling edge transmit‐
ted to the output (Default 1 ms)
The may. delay value for one delay is: 65535
ms
The falling edge is configured with the OffDelay
setting.
DEVICE FUNCTIONS 8
8017853/2019-06-06 | SICK O P E R A T I N G I N S T R U C T I O N | Sensor Integration Gateway - SIG200
89
Subject to change without notice