Description Measures the pulse time of the digital input
signal triggered by the rising or falling edge
depending on the configuration.
Information: There is no reset. Once it reaches
the High Limit it stops.
Number of inputs 1
Input data type Input 1 ("Enable"): 1-bit
Input description input: input signal
Number of outputs 3
Output data type Output 1 ("High"): 1-bit
Output 2 ("Time"): UInteger 16
Output 3 ("Low"): 1-bit
Output description low: This output is active when the time output
is lower than LowLimit (Information: The 1 ms
option is not available).
time: This value increments once per Time‐
Base whenever input is active.
high: This output is active when the time out‐
put is higher than the HighLimit.
Settings EnableMode: Enable mode to define which
time to be measured. Either between rising
and falling edge of the input signal or between
falling and rising edge (Default Rising Edge)
TimeBass: Select the time base for the time
measurement (Default 100 ms)
HighLimit: Defines a high value for the
boolean output signal which is set when the
timer value exceeds the defined high limit
(Default 0)
LowLimit: Defines a low value for the boolean
output signal which is set when the timer value
is lower than the defined low limit (Default 0)
Description Invert the input signal with a logical NOT.
Number of inputs 1
Input data type 1-bit (future extension: or n-bit)
Input description levelA: first input value
Number of outputs 1
Output data type Identical to input data type
Output description level: the input signal will be inverted with a
logical not. Example: a high signal gets con‐
verted into a low signal.
Settings No settings available
8 DEVICE FUNCTIONS
90
O P E R A T I N G I N S T R U C T I O N | Sensor Integration Gateway - SIG200 8017853/2019-06-06 | SICK
Subject to change without notice
To Next Page
Loading...
