AC MUM0114 rev. 04 - 18 -
SH130
10. WINCH LUBRICATION
Shell Omala S4 WE synthec oil is supplied with the winch. Ensure that
the oil drain screw is ghtly closed and check that the oil level is at the
halfway point on the transparent gauge.
Shell Omala S4 WE is non-miscible with mineral oils and with most
other types of synthec lubricants. Be careful, therefore, to avoid mix-
tures forming during rell operaons, both when draining and when
topping up.
Mineral oils are not permied for use in the machine.
The exclusive use of Shell Omala S4 WE oils is advisable.
Contact Sicor s.p.a. for informaon on using lubricants other than
those indicated in this manual, and for instrucon on the relevant
replacement procedure.
Do not use other types of oil!
The SH130 winch requires 3,7 litres of oil.
10.1. CHANGING THE OIL
We recommend to change oil aer 600 hours of winch operaon,
ensuring correct uxing within the reducon unit.
Subsequent lubricant changes should be performed every 24/36
months depending on the condions of use of the machine. If the
oil temperature exceeds 85 °C (during intense use), the oil must
be changed every 2 years. The oil must also be changed if it is
contaminated by other substances (e.g. water or topping up with
unrecommended oil).
To change the oil:
- read the “Safety Requirements” chapter.
- disconnect the electrical power supply to the winch.
- wait for at least one hour from machine shut-down so that the oil in the winch cools
down.
① Oil level
② Oil filling
③ Oil discharge
1
2
Right horizontal winch
3
2
1
Vercal winch
3
1
2
Le horizontal winch
3
To Next Page
Loading...
Need help?
General
