Fail-Safe Modules
7.8 1 F-RO DC24V/AC24..230V/5A Digital Electronic Module
ET 200S Distributed I/O System - Fail-Safe Modules
180 Installation and Operating Manual, 08/2008, A5E00103686-07
Terminal Designation
9 OUT 1
10 OUT 1
NO contact, channel 0 for fail-safe switching of load 1
11 OUT 2
12 OUT 2
NO contact, channel 1 for fail-safe switching of load 2
A12 AUX 1 At TM-E...46-A1: AUX 1 bus implemented. Connection to terminals A3
to A16 for any PE connection.
Individual grouping of load current supplies is supported.
A11 AUX 1 At TM-E...46-A1: AUX 1 bus implemented. Connection to terminals A3
to A16 for any PE connection.
Individual grouping of load current supplies is supported.
13 OUT 1
14 OUT 1
NO contact, channel 0 for fail-safe switching of load 1
15 OUT 2
16 OUT 2
NO contact, channel 1 for fail-safe switching of load 2
A16 AUX 1 At TM-E...46-A1: AUX 1 bus implemented. Connection to terminals A3
to A16 for any PE connection.
Individual grouping of load current supplies is supported.
A15 AUX 1 At TM-E...46-A1: AUX 1 bus implemented. Connection to terminals A3
to A16 for any PE connection.
Individual grouping of load current supplies is supported.
CAUTION
Wire these terminals in parallel if high currents are generated at OUT 1 or OUT 2 (≥ 50% of
the rated current of the respective output channel):
• For OUT 1: Terminals 9/10 and 13/14
• For OUT 2: Terminals 11/12 and 15/16
Otherwise, high current loads may cause the terminals to heat up.
To Next Page
Loading...