Operating the Control Panel
5.5 Network and Internet
Unified Comfort Panels
90 Operating Instructions, 03/2020, A5E46641217-AA
IP address
● "Obtain an IP address via DHCP" (default setting): Option to automatically assign the IP
address via the DHCP server.
● "Specify an IP address": Option to manually assign the IP address.
● "IP address": IP address of the X2 interface. The IP address must be unique in the local
network. The IP addresses of X2 and X1 interfaces must be located in different subnets.
● "Subnet mask": Subnet mask for the IP address of X2 interface.
● "Default gateway": IP address of the gateway (router) if several different local networks
are used.
● "Set IP address": Button for saving the specified IP address parameters.
Note
If you select the option "Obtain an IP a
ddress via DHCP", this setting will not be overwritten
when the project is loaded. If you select the option "Specifiy an IP address", you can also
configure the network address in the "Devices & Networks" editor in WinCC. You can find
more information in t
he TIA Portal information system.
Ethernet parameters Port
● "Activate this port for use": Option to enable or disable the port. The default setting is
"Activated".
● "Mode and speed": List for selecting the transmission type and transmission rate for the
port.
Selection options:
– "Automatic" (default setting)
– "10Mbps / HDX" (10 Mbps, half duplex)
– "10Mbps / FDX" (10 Mbps, full duplex)
– "100Mbps / HDX" (100 Mbps, half duplex)
– "100Mbps / FDX" (100 Mbps, full duplex)
Use the default setting "Automatic" preferably.
To Next Page
Loading...
