IM151-1 HIGH FEATURE interface module (6ES7151-1BA02-0AB0)
Manual, 03/2008, A5E01075975-02
7
Properties
1
1.1 IM151-1 HIGH FEATURE interface module (6ES7151-1BA02-0AB0)
Properties
The IM151-1 HIGH FEATURE interface module has the following features:
● It connects the ET 200S with PROFIBUS DP via the RS 485 interface.
● There is no restriction on the SIMATIC S7 for the maximum parameter length. It is
normally 244 bits.
● The maximum address space is 244 bytes for inputs and 244 bytes for outputs.
● Operation as a DPV0 or DPV1 slave
● A maximum of 63 modules can be operated with the IM151-1 HIGH FEATURE.
● The maximum bus length at the backplane bus is 2 m.
● Supports option handling and the status byte for power modules.
● synchronizable with the DP cycle (cycle synchronization).
● The firmware can be updated via PROFIBUS DP using HW CONFIG.
● Safety-related I-slave-slave-communication via PROFIBUS DP. You can find the
description of this function in the
S7 Distributed Safety Configuration and Programming
manual.
● Identification data
● Direct data exchange
● Operation as DPV1 slave on the Y switching
● Use of fail-safe modules
To Next Page
Loading...
Need help?
General
