Siemens 6ES7647-0BA00-1YA2 - Installing Half-Size Mini Pcie Card

Expand device
5.3 Install Mini PCIe card
SIMATIC IOT2050
Operating Instructions, 03/2020, A5E39456816-AA
35
5.3.2 Installing half-size Mini PCIe card
Requirement
● The device is disconnected from the power supply.
● A half-size Mini PCIe card
● One M2 screw
Procedure
You can install the half-size Mini PCIe card by two ways.
● Expand the length of half-size Mini PCIe card with a expansion card. Then follow t
he
pr
ocedure in Installing Mini PCIe card (Page 32)
● Install the half-szie Mini PCle cards directly.
The following example describes the installation of a half-size Mini PCIe card, including
mounting of the antenna jacks. If you install a different Mini PCIe card, the work steps 5 and
6 are not required.
Follow steps 1 to 4 as described in Installing Mini PCIe card (Page 32) to open the top
housing with shield cover. Then the following steps:
1. Remove one standoff for Mini PCIe card from motherboard.
2. Install the standoff to the place as shown in the picture.
3. I
nsert the half-size Mini PCIe card in the Mini PCIe interface on the motherboard as
illustrated.
4. Fix the mini PCIe card with one M2 screw.