To Next PageTo Next PageWhat to do if the Siemens Gateway user button doesn't work when the Arduino shield reset pin is working?
The user button and the Arduino interface reset pin cannot work at the same time. To resolve this, avoid using the user button and the Arduino interface reset pin simultaneously.
Why does the Siemens Gateway host monitor flash black when inserting the DC connecting terminal?
The host monitor flashes black because you turned the switch on before connecting the DC connecting terminal. To prevent this, avoid turning the device on or off by plugging or unplugging the DC connecting terminal. Instead, use an external switch to control the power of the device.
General| Product Type | Gateway |
|---|---|
| Product type designation | 6ES7647-0BA00-1YA2 |
| Manufacturer | Siemens |
| Model Number | 6ES7647-0BA00-1YA2 |
| Communication Interface | Ethernet |
| Transfer rate | 10/100 Mbps |
| Supply voltage | 24 V DC |
| Relative Humidity | 5 to 95 % (non-condensing) |
| Protection Class | IP20 |
| Protocols | TCP/IP, UDP |
| Interfaces | 1 x RJ45, 1 x PROFIBUS |
| Operating Temperature | 0 to +60 °C |
| Storage Temperature | -40 °C to 70 °C |
| Power Consumption | 5 W (typical) |
Describes the SIMATIC IOT2050 as a robust, compact, and flexible IoT solution.
Covers critical safety warnings for installation and operation, including voltages and expansions.
Details steps for checking delivery and preparing the device for installation.
Instructions on how to securely mount the device, including clearances and types.
Procedures for connecting power, function earth, and other peripherals safely.
Provides essential information and cautions for commissioning the device, including forum access.
Guidance on authorized repairs and safety precautions for opening the device.
Provides key technical data such as order number, weight, power, and protection class.
Shows a detailed diagram of the motherboard and its components.
Describes the function and pin assignment of external ports.
Details the D-sub 9-pin serial port and its RS232/422/485 assignments.
Pin assignments for the Arduino shield connector.
