Siemens 6SL3210-1PE23-3AL0 - 1 Introduction

Siemens PM240-2_EN_rev00-30082019.docx 1-1
1 INTRODUCTION
SIEMENS PM240 is an inverter with special software for hydraulic systems, that controls the phase of travel
in upward direction and, with prearranged hydraulic power units, also the travel in downward direction. This
inverter is able to work both with old and new hydraulic power units.
The advantages are:
 Reduction of starting current peaks. The maximum starting current is near the rated current.
 Power factor correction of absorbed current. Cosφ≥0.98.
 Energy saving.
 Run comfort optimization.
 Adjustable inspection speed.
 Possibility of setting a maximum limit for the absorbed power from the mains, to limit the
installed power.
NOTE:
For further insights regarding the functions of the Siemens PM240-2, refer to the corresponding manuals
Siemens, available on the website of the company.
All information, product manuals and details, could be found at the internet address:
http://support.automation.siemens.com entering the 16-digit product code (6SL3210…) that you can found
on the inverter or on the present manual in the technical data section.