A 01/13 2-channel Binary Signal Transducer Page 7 of 40
s
Page 6 of 40 2-channel Binary Signal Transducer A 01/13
s
Safety Notes
These operating instructions contain notes that are to be complied with
for your personal safety as well as to avoid property damages. These
notes are marked by a triangular warning symbol and the different degrees
of danger are categorized as follows:
V Danger
Disregard of the corresponding precautionary measures will cause death,
severe bodiliy injury or considerable property damage.
V Warning
Disregard of the corresponding precautionary measures may cause death,
severe bodiliy injury or considerable property damage.
V Attention
Disregard of the corresponding precautionary measures may lead to
slight bodiliy injury or minor property damage.
Note
Shall draw your attention to special information on the product, product
handling or the corresponding section of the documentation.
Qualified personnel
Commissioning and operation of the equipment is to be performed by
qualified personnel only. In the context of safety notes in this manual,
the term qualified personnel refers to persons authorized to perform
commissioning, grounding and labelling of devices, systems and electrical
circuitries.
Intended Use
Please observe the following:
V Warning
The device must be operated only within the scope of its intended use
according to these operating instructions and in connection with third-
party equipment or compounds recommended or accepted by Siemens.
Faultless and safe operation of the product require proper transport,
storage, mounting and installation as well as careful operation and
maintenance.
Exclusion of liability
The contents of this document have been reviewed on their compliance
with the hardware and software described therein. Yet, deviations cannot
be excluded, so that we cannot guarantee full compliance. The
specifications in this document are, however, reviewed at regular intervals.
Necessary corrections will be included in the next edition. You are invited
to send us your suggestions for improvement.
Copyright
Copyright Siemens AG 1999. All rights reserved.
Transmission or reproduction of this document, as well as the use and
forwarding of its contents is not permitted without express written
authority. Offenders will be liable for damages. All rights, including rights
created by patent grant or registration of a utility model or design, are
reserved.
Subject to technical changes without notice.
To Next Page
Loading...
Need help?
General
