24V On/Off with 1 Set AUX Switches
Model – A126.530
Fig. 5: Model A126.530 Wiring
Fig. 6: Model A126.530 Servo Controller.
A-Series 530 lb-in 24V Modulating Actuator with
Servo Controller
To control the actuator remotely from a process controller in a modulating application,
you must apply the proper supply voltage and the configured control signal to the
Servo controller electronics package. The control signal may be applied locally from a
hand-held signal generator or remotely from a process controller.
The 24V Servo Controller may be powered from either 24 Vdc or a 24 Vac, 100 VA
Class 2 power supply. In the case of an over-torque fault, the electronics are
configured to limit maximum current, which will effectively lock the rotor.
To Next Page
Loading...
