iv
Document No.: COM-00-05-16 June 2006, Revised June 2014
Version: C.1
Page 2-7, paragraph 2.3, EQUIPMENT CONNECTION TO WAG
• Added subparagraph 2.3.6, Office System Interface Configuration,
including Figure 2-7 to support text
Page 2-8, paragraph 2.4, CONFIGURATION USING TERMINAL
EMULATION SOFTWARE, Step 3
• Added note “If the screen shown in figure 2-9…”
Page 2-9, paragraph 2.4, CONFIGURATION USING TERMINAL
EMULATION SOFTWARE, Step 4
• Changed “…WAG…” to “…WAGs…”
Page 2-9, paragraph 2.4, CONFIGURATION USING TERMINAL
EMULATION SOFTWARE, first NOTE
• Changed last sentence in note to read, “Wait at least 3 seconds and
then type +++ and wait 3 seconds for the system to command
mode…”
Page 2-10, paragraph 2.5, CONFIGURATION USING TELNET
• Changed “To Login Using…” to read, “To log in using…”
Page 2-12, paragraph 2.6, CONFIGURATION OF THE WAG UNIT,
subparagraph 2.6.1
• Changed subparagraph title to read “Type 7 ATCS Address” and
reworded entire subparagraph, adding Figure 2-13, Type 7 ATCS
Address Configuration Screen with functional explanations
Page 2-13, subparagraph 2.6.2, Type 3 ATCS Address
• Item 1: replaced Figure 2-14 ATCS Address Screen with one that
specifies the second line ATCS address item as, “Enter the NN…”
Page 2-13, paragraph 2.6.2, Type 3 ATCS Address, subparagraph 2.6.2
• Changed subparagraph title to read “Type 3 ATCS Address” and
reworded entire subparagraph, adding Figure 2-14, Type 3 ATCS
Address Configuration Screen with functional explanations
Page 2-
15, paragraph 2.6, CONFIGURATION OF THE WAG, subparagraph
2.6.4
• Reformatted paragraph to “unwrap” Figure 2-16 from the text for
steps 1 through 4
Page 2-
15, paragraph 2.6, CONFIGURATION OF THE WAG, subparagraph
2.6.5
• Changed subparagraph title to read “WAG Test Mode” and reworded
entire subparagraph to read “This function is for future…..”. All
subparagraphs in this section renumbered accordingly.
Page 2-
18, paragraph 2.6, CONFIGURATION OF THE WAG, subparagraph
2.6.8
• Removed last sentence (“To specify the routing table never
expires…”) from step 2.
Page 2-23, paragraph 2.6, CONFIGURATION OF THE WAG, su
To Next Page