Siemens A53457 - 3 Operation; Introduction; Table 3-1. WAG Commands

OPERATION
3-1
Document No.: COM-00-05-16 June 2006, Revised June 2014
Version: C.1
SECTION 3
OPERATION
3.0 OPERATION
3.1 INTRODUCTION
This section explains the available commands with respect to the WAG.
Table 3-1. WAG Commands
Command
Shorthand
Description
?
?
Gets a list of keyboard commands.
Break
bre
Breaks to the boot monitor.
Command
com
Returns the WAG serial interface to command mode from Telnet.
Config
con
Allows changes to the WAG configuration.
Data
dat
Returns the WAG serial interface to data mode.
log1
log1
Shows the event log.
log2
log2
Clears the log.
Log3
Log3
Enables/disables event log streaming.
Ping
pin
Sends a PING to an IP address.
Project
pro
Shows system level information about the WAG.
Reqip
reqip
Request a new IP address from a DHCP server.
Restart
res
Reboots the WAG.
Revisions
rev
Displays all WAG software version information.
Routes
rou
Shows the route table.
Rping
rpi
Pings a route ID.
Sconfig
sco
Shows current configuration settings.
Smac
sma
Shows MAC addresses in the route table.
Status
sta
Displays status information of system operation.
Sdate
sda
Sets the current date.
Stime
sti
Sets the time of day.
Testmode
tes
Sets/stops the WAG test mode (0, 1, 2, or 3).
Trace
tra
Traces one or more interfaces.
Ttimes
ttimes
Displays WAG task usage.
Tunnel
tun
Connects RAW serial interface tunnel.
Verbosity
ver
Sends run-time messages out serial interface when unit is in
command mode.
Wagreport
wagreport
Search for and report other WAGs.
Winkwag
win
Sends WINK request to a WAG.
Xfiles
xfi
Uploads and downloads files.
NOTE
The WAG serial interface must be in Command mode before the following
commands will work.