Safety Precautions
DANGER Hazardous Voltage. Will cause death or serious injury. Only to be used by
qualified personnel.
Turn off and lock out power supplying equipment before installing AFCI.
Safety Instructions
1. AFCI circuit breakers must be installed and serviced by a qualified electrician only.
2. To be installed only on a single phase 120VAC grounded system.
3. To prevent severe shock or electrocution, always turn the power off before working on or inside
equipment.
4. Replace all doors and covers before turning on power to this equipment.
Do not open. No user serviceable parts inside. If damaged, please return to Siemens Industry Inc. at:
Parkway Lane
Peachtree Corners, GA , USA
WARNING: This device is only for use on single phase V circuits. DO NOT connect to higher
voltage electrical supplies. Connecting this device to any circuit with voltages above V will
cause damage to the equipment and could result in injury or death.
CAUTION: DO NOT use if device appears damaged in any way.
Hazard of Equipment Damage. Will cause Damage to the AFCI Module. Do not reverse-feed or
back-wire. Do not subject to megger, high voltage, or hi-pot test. Remove the breaker before
hi-pot occurs on the system or on the circuit.
Risk Of Danger
It is important that users of this device read, understand, and follow all warnings, cautions, safety
information, and instructions in this manual before operating this device. Failure to follow instructions
could result in death or serious injury.
Quick Start Guide AFCI Diagnostic Circuit Breaker
To Next Page
Loading...
