Menu Overview
Status Screen
The Status screen will provide basic data about the breaker connected. The most useful section for this
screen is the RF Noise Level. Watch for levels that fluctuate or exceed the Green bars for any potential
unwanted trip issues. In addition to RF Noise, the Load Current can be monitored.
RF Noise may cause unwanted tripping with
enough Load Current. The more bars, the more
likely RF noise interference is causing unwanted
tripping.
Use waveform data (using the Record tab) to help
determine if the noise is an issue.
Breaker connection status is displayed at the top of
the App.
NOTE: The phone must remain within feet of
the breaker to maintain connection.
In addition to RF noise, the Load Current can be
monitored.
There are menu options located at the bottom
of the screen.
Quick Start Guide AFCI Diagnostic Circuit Breaker
To Next Page
Loading...
