Capturing Data
Download a previous Waveform Capture – Last Trip Waveform
Use this setting if the breaker was installed and has recorded a trip event.
After the breaker trips, reconnect to the breaker by turning the breaker OFF then ON. Next press the bluetooth
icon in the top right corner. If the breaker does not reconnect, follow the steps described in the Connecting
you Mobile Device to the Diagnostic Breaker section of the guide.
Next, follow the steps below:
3.
. Tap Record from the bottom menu options.
. Under the Settings header, click the
arrow to expand the menu options.
. Choose “Last Trip Waveform” as the Trigger
Source.
. Tap Save Settings.
. Expand Record Info and enter site
information.
. Expand Graph.
. Scroll down until you see the blue Record
button:
Continued on next page
icon indicates the breaker is not connected to the app
icon indicates the breaker is connected to the app
AFCI Diagnostic Circuit Breaker Quick Start Guide
To Next Page
Loading...
