Setting Up a Waveform Capture – Last Trip Waveform (continued)
Once you tap the Record button, the app will display
“Waiting for capture”, as shown in the image.
A few seconds later, the breaker should display the
message “Fetching records”. Then, the graph will update
with the information that was stored from the last trip
event.
If you do not see the “Fetching Records” prompt. You may
be too far away from the load center. Ensure you are
within ft. of the load center.
After the breaker loads the data, a graph will be displayed,
showing Load Current and RSSI (RF noise).
Tap the icon to save the graph to your mobile device
to view later or share later using the History tab.
Tap the icon to share the data via email.
TIP: You can also pinch to zoom on the graph to change
the x-axis and y-axis scaling.
Quick Start Guide AFCI Diagnostic Circuit Breaker
To Next Page
Loading...
