Setting Up a Waveform Capture – Manual Trigger (continued)
Once you tap the Record button, the app will display
“Waiting for capture”, as shown in the image.
A few seconds later, the breaker should display the
message “Fetching records”.
A waveform from the manually triggered event will then
be displayed in the Graph section.
After data is captured, a graph will be displayed, showing
Load Current and RSSI (RF noise).
Tap the icon to save the graph to your mobile device
to view or share later.
Tap the icon to share the data via email.
TIP: You can also pinch to zoom on the graph to change
the x-axis and y-axis scaling.
Quick Start Guide AFCI Diagnostic Circuit Breaker
To Next Page
Loading...
