Siemens AVS74 - Set important plant parameters.

6
Evaluate plant and set
Operating service/setting pages
68
Siemens Graphical User Interface UI400 CE1U2348en
Building Technologies 2014-06-03
6.2.3 Set important plant parameters.
Adjustable:
1. Comfort setpoint
2. Reduced setpoint
3. Protection setpoint
4. Characteristic curve slope (heating) and flow setpoint at OT 25 °C or 35 °C
(cooling).
5. Summer/winter heating limit (heating) and cooling limit at OT (cooling).
The parameters
adapt the plant to meet your needs.
The controller manual provides technical details on these parameters.
l The service/setting pages ( ) are preselected in the navigation bar.
Proceed as follows to set a plant parameter:
1. Turn the control knob and select the "Settings".
2. Press the control knob.
'Special operations' opens. The title of the settings page is preselected.
3. Push the control knob to select the setting page title.
4. Turn the control knob to go to other setting pages.
5. Push and turn the control knob to go to the work area of a setting page.
6. Set the values as per the needs of your building or living zone.
7. Exit the settings page with "Back".
Prerequisites