Siemens AVS74 - Start commissioning wizards

8
Analyze plant and set
Set plant and troubleshoot
80
Siemens Graphical User Interface UI400 CE1U2348en
Building Technologies 2014-06-03
8.2.2 Start commissioning wizards
You can start the commissioning wizard at any time via the menu item described
below and benefit from the structured processing of commissioning parameters.
The scope of the commissioning wizard differs between the room unit QAA74 and
operator unit AVS74.
Section "Commission plant using the commissioning wizard [➙ 71]" includes a
sketch of the commissioning wizard structure and notes about its start-up
behavior.
QAA74
l The Adjust/repair pages (
) are selected.
Proceed as follows to start the commissioning wizard:
From the topic list, select "Commissioning wizard" and confirm the selection.
Notes on these parameters are available in Section "
Room/operator unit
parameters [➙ 86]".
AVS74
l The Adjust/repair pages (
) are selected.
Proceed as follows to start the commissioning wizard:
From the topic list, select "Commissioning wizard" and confirm the selection.
Notes on plant parameters are available in the user's guide for your controller.
Prerequisites
Prerequisites