Siemens CP 1243-1 - 2.3 Electrical connectors

LEDs and connectors
2.3 Electrical connectors
CP 1243-1
30 Operating Instructions, 04/2017, C79000-G8976-C365-03
2.3
Electrical connectors
2.3.1
Power supply
Power supply
The CM is supplied with power from the backplane bus. It does not require a separate power
supply.
2.3.2
Ethernet interface X1P1
Ethernet interface
The Ethernet connector is located behind the lower hinged cover of the module. The
interface is an RJ-45 jack according to IEEE 802.3.
The pin assignment and other data relating to the Ethernet interface can be found in the
section Technical data (Page 133).