Siemens CP 1243-1 - 4.8 Partner stations

Configuration
4.8 Partner stations
CP 1243-1
54 Operating Instructions, 04/2017, C79000-G8976-C365-03
Configuration
●
"Enable SNMP"
If the option is enabled, communication via SNMPv1 is enabled on the CP.
If the option is disabled, queries from SNMP clients are not replied to by the CP either via
SNMPv1 or via SNMPv3.
4.8
Partner stations
The parameter group is only displayed when telecontrol communication is enabled.
4.8.1
Partner stations > General parameters
Listener port
Only with DNP3 / IEC
Here the listener port of the module, port for connection requests of the communications
partner are displayed.
● Default for the DNP3 protocol: 20000
● Default for the IEC protocol: 2404
You can change the port number for the module. Keep in mind the settings on the
communications partner (master).
Permitted range: 1024...65535
Partner'X' / telecontrol server
●
Activate partner
– TeleControl Basic
The telecontrol server is enabled as the only possible partner in the default settings.
– DNP3 / IEC
By enabling the option the master that can then be configured is enabled for
communication.
●
Partner number
The partner number is assigned by the system. It is required during data point
configuration to assign data points to their communications partners.