Siemens CU240B-2 - Page 25

Installing
3.3 Installing Control Unit
Converter with Control Units CU230P-2; CU240B-2; CU240E-2
Getting Started, 04/2014, A5E32885834B AB
25
Factory setting of the CU240B-2
The factory setting of the terminals depends on whether the Control Unit has a PROFIBUS /
PROFINET interface.
Factory setting of the terminals for Control Units without
PROFIBUS interface
Factory setting of the terminals for Control Units with
PROFIBUS interface
Fieldbus interface is not active.
The function of the fieldbus interface depends on DI 3.