Siemens EQ.500 classic - Before Using for the First Time; Initial Start-Up Procedure; Filling the Water Tank; Filling the Coffee Bean Container

en Before using for the first time
56
accessories Retail Customer service
Cleaning tablets TZ80001A
TZ80001B
00312097
00312098
Descaling tablets TZ80002A
TZ80002B
00312094
00312095
Water filter TZ70003 00575491
Water filter pack of 3 TZ70033 -
Microfibre cloth - 00460770
Care set TZ80004A
TZ80004B
00312105
00312106
Before using for the first time
Before using for the
first time
Configure the basic settings. Clean
the appliance and individual parts.
Perform the initial start-up
▶
After connecting the appliance to
the power supply, configure the
settings for initial start-up.
Note:The automatic display for se-
lection of the language and water
hardness only appears when the ap-
pliance is switched on for the first
time.
Tip:You can change the settings at
any time.
→"Basic settings", Page68
Fill the water tank
Fill the water tank each day with
fresh, cold, non-carbonated water.
1. Open the lid.
2. Remove the water tank using the
recessed grip.
3. Rinse the water tank.
4. Fill the water tank up to the "max"
mark.
5. Insert the water tank into the
holder, keeping it straight.
6. Close the lid.
Fill coffee bean container
ATTENTION!
Unsuitable beans can block up the
grinder.
▶
Only use pure, roasted bean mixes
that are suitable for use in fully
automatic coffee or espresso ma-
chines.
▶
Do not use glazed coffee beans.
▶
Do not use caramelised coffee
beans.
▶
Do not use coffee beans that have
been treated with additives con-
taining sugar.
▶
Do not add ground coffee.
1. Open the lid.
2. Fill with the coffee beans.
The appliance will adjust to the
coffee beans with the next dis-
pensing process.
3. Close the lid.
Tip:To keep the coffee beans at
their best, store them in a sealed
container in a cool place.
You can keep the coffee beans in the
bean container for a number of days
without them losing their aroma.